I designed my maze in the program inventor. It was very simple to design. I just used the line tool and just offset it by .25 inches. Then save it and upload to fusion 360. Now we will want to generate a tool path for it it. You should only need one tool path for the inside of the maze. Select the bottom of the maze and it should highlight the whole maze, then choose adaptive clearing. Save this to a flash drive and then bring it over to the computer by the router. To set up the foam you will have to use the double sided tape and stick it to the router bed. Once done you will want to set your x, y, and z. You will use the computer to do this and put the bit over the bottom right corner of the foam. Now you will zero x, y, and z. You can press start and watch the router cut out your maze. It should take about ten minutes max to cut on the router. My maze only took about eight minutes to cut out.
|